The integrated protocol model of BALLUFF start/stop sensors

Discuss and troubleshoot RMCTools along with RMC70, RMC150, and RMC200 motion controllers.

The integrated protocol model of BALLUFF start/stop sensors

Postby phil.liu » Thu Aug 23, 2018 5:41 am

A normal START/STOP signal consists of a interrogation signal and a start-stop signal.
But there is a special mode in the BALLUFF sensor,You can download the attachment and view the document on page 14, and introduces the common DPI and special IP mode.
When the interrogation signal (INIT) at 1-5 us, sensor into DPI mode, when the interrogation signal (INIT) at 10 to 50 us, sensor into IP mode.
I know we can receive RMC75E - MA2 DPI pattern of data, but I want to know whether can support IP mode.If can be supported, I should take what Settings
Attachments
DOK_919698_02_000.pdf
Page NO.14
(5 MiB) Downloaded 9 times
phil.liu
 
Posts: 5
Joined: Mon Sep 25, 2017 6:20 am

Re: The integrated protocol model of BALLUFF start/stop sens

Postby phil.liu » Thu Aug 23, 2018 5:48 am

20180823214049.png
20180823214049.png (241.95 KiB) Viewed 168 times
phil.liu
 
Posts: 5
Joined: Mon Sep 25, 2017 6:20 am

Re: The integrated protocol model of BALLUFF start/stop sens

Postby phil.liu » Thu Aug 23, 2018 5:50 am

20180823214952.png
20180823214952.png (123.14 KiB) Viewed 167 times
phil.liu
 
Posts: 5
Joined: Mon Sep 25, 2017 6:20 am

Re: The integrated protocol model of BALLUFF start/stop sens

Postby Jacob Paso » Thu Aug 23, 2018 7:41 am

Phil,

The RMC's do not support the Balluff IP mode.
Jacob Paso
 
Posts: 519
Joined: Thu Jan 03, 2008 3:18 pm


Return to RMCTools

Who is online

Users browsing this forum: No registered users and 1 guest

cron