When you search for something in RMCTools, the returned results give you a line number to tell you where the text was found:
ycle2_Impulse(0) : Action 0 line 5 Status.Cyc2_Fail := FALSE;
Cycle2_Impulse(3) : Condition 1 Status.Cyc2_Fail
Cycle2_Impulse(4) : Condition 1 Status.Cyc2_Fail
Cycle2_Impulse(6) : Condition 0 Status.Cyc2_Fail
Cycle2_Impulse(7) : Condition 2 Status.Cyc2_Fail
Cycle2_Impulse(9) : Action 0 line 5 Status.Cyc2_Fail := TRUE;
CycleMonitor(1) : Action 0 line 21 Cyc2_Fail_Time_Dint := REAL_TO_DINT(Cyc2_Fail_Time*1000.0);
CycleMonitor(1) : Action 0 line 21 := REAL_TO_DINT(Cyc2_Fail_Time*1000.0);
CycleMonitor(1) : Action 0 line 47 IF _SysMS - Cyc2_Fault_Timer_ms > Cyc2_Fail_Time_Dint THEN
CycleMonitor(1) : Action 0 line 48 Status.Cyc2_Fail := TRUE;
CycleMonitor(1) : Action 0 line 73 IF _SysMS - Cyc2_Fault_Timer_ms > Cyc2_Fail_Time_Dint THEN
CycleMonitor(1) : Action 0 line 74 Status.Cyc2_Fail := TRUE;
However, When you go to the expression block, there is no way that I can find to tell what line you are on. For small expressions this is not an issue but for something with a bit of length to it, it would be very helpful to know what line you are on.
Thanks