Question about Negative Overtravel parameters

Discuss and troubleshoot RMCTools along with RMC70, RMC150, and RMC200 motion controllers.

Question about Negative Overtravel parameters

Postby mars_bruce_lee » Fri Dec 07, 2018 7:21 pm

Mentioned in the help
"Note:This bit turns on only when exceeding the limit or attempting to go further past the limit. It will turn off if a command is issued that keeps the axis in the same place or moves it toward the limit."

If the axis is outside the range of the negative limit,In this case, move the axis in the opposite direction,Will Negative Overtravel trigger?

Did a test, still report Negative Overtravel.I think it should not be triggered at this time because it is triggered in the opposite direction. I used instruction Open Loop Rate
Attachments
Plot1.rmcplots
Plot
(2.82 MiB) Downloaded 3 times
截图01.png
截图01.png (82.22 KiB) Viewed 30 times
mars_bruce_lee
 
Posts: 210
Joined: Thu Dec 26, 2013 10:12 pm

Re: Question about Negative Overtravel parameters

Postby Jacob Paso » Mon Dec 10, 2018 8:58 am

I tried it on my system, and the Overtravel error bit did turn off correctly when the axis was beyond the travel limit and I sent an Open Loop Rate command to move back toward the travel range. I can't figure out what exactly is going on in your system. Perhaps if you attach both a plot and event log, that may help.
Jacob Paso
 
Posts: 530
Joined: Thu Jan 03, 2008 3:18 pm


Return to RMCTools

Who is online

Users browsing this forum: No registered users and 1 guest

cron